Use 1 part HYDROC ECO SUPER XL to approximately
40 parts water.
Method of Application:
The above solution should be sprayed upon the
entire area of the oil spill under pressure.
Begin at the outer edge, spraying the above
mixture onto the oil slick. Continue spraying
on oil slick in decreasing concentric pattern
until entire oil slick has been sprayed.
Normal open water wave and wind action will
provide agitation and aid in dispersion, However,
if in quiet waters – use high pressure
sprayer or other means of water agitation to
replace normal wave action.
Patrol area and spray mixture upon any remaining
oil slick residue.
of HYDROC Eco Super XL
Under the above condition, will not harm marine
Holds oil in water solution, therefore oil loses
its' identity as an oil and takes on characteristic
of a water soluble and will not recombine. Oil
biodegrades naturally in sunlight.
Easily applied with existing ship's equipment,
e.g. Duplex Foam Proportimer provides mixing
ratio of approximately 1 part HYDROC to 16 parts
water. Therefore, 1 part HYDROC to 2.5 parts
water should be placed in proportimer tanks.
Use salt water - conserve freshwater.
Economy of funds and storage space.
Oil Spill should be sprayed with above mixture
as soon after spill as possible for best results
and economy of operations.
For information and planning: 1 litre of HYDROC
will disperse approximately 9 litres of crude
oil or Bunker C when applied in the above mixture
and agitated with pressure of 90-120 PSI water.
The amount of HYDROC required to disperse or
clean up an oil spill will vary with wind and
sea conditions, amount, type and thickness of
the oil spill and the time delay from spill
to application of the HYDROC.
For best results, spray mixture of HYDROC and
water upon the spill. Undiluted HYDROC is not
as effective, will take longer and increases
costs of the clean-up operation.
Check with local authorities before using to
preclude violating any governmental restrictions
HYDROC the ENVIRONMENTALLY SAFE ALTERNATIVE